PUSH-TO-OPEN INSTALLATION
1. Position the supplied drill jig [220-1236] in the bottom corner of the cabinet, opposite the hinges. Be sure the flange of the jig is
pressed against the flange of the cabinet as shown. Using the supplied #31 (0.120") drill bit [203-1546], drill three holes into the side of
the cabinet using the jig holes as a guide.
2. Remove the jig and position the push-to-open base plate as shown so all three screw holes line up with the drilled holes. Using a
#2 Phillips-head screwdriver, insert the supplied #6-32 screws [203-1493] and mount the base plate in place.
3. Clip the push-to-open cover onto the baseplate, starting in the back, then pressing inward until an audible click is heard.
4. Insert the push-to-open mechanism into the cover's opening.
5. Swing the cover closed until an audible click is heard.
6. Press the push-to-open mechanism inward until the front face is flush with the outer cover. Rotate the push-to-open mechanism to
adjust the door's position when closed.
1
4
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
2
5
8
3
6
Part no. CB-209-1441 06/15/2022
Murray Hill Cabinet
