Mirror Installation - Robern CRAFT Serie Instrucciones De Montaje

PREP THE WALL
1. Locate the studs and drill four holes using a 3/32" drill bit.
2. If no stud is available, drill a 1/4" hole for each wall anchor and use the supplied wall anchors*.
3. Use four screws provided to attach cleats to the wall.
4. Tighten screws until tight. When anchors are used, keep turning screw at least 4 more times as shown.
4X
*Actual wall anchor many differ from type shown.

MIRROR INSTALLATION

1. Hang the mirror on the cleats and check level, adjust horizontally to desired location (This may require two people).
1
Wall
Mirror
Cleat
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A. Part no. 209-1440 04/13/2022
4
800.877.2376 www.robern.com Craft Series Mirror