Kränzle K 1152 TS T Instrucciones De Servicio página 42

Motor protection switch
The motor is protected from overload by a motor protection switch, which cuts out the motor
in the event of overload. However should the switch trip frequently, the cause of the malfunc-
tion should be located and rectified (see page 40).
Replacements and inspection work should only be
performed by qualified persons when the machine is
disconnected from the power supply, i.e. with plug pulled
out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spraying device supplied with the machine are made of high grade
material, they are also optimized for the machine and marked as required by the appropriate
regulations. (max. hose length 20 m)
If replacement parts are required, only such parts that are
authorized by the manufacturer may be used. The warranty
is automatically void if spare parts of third-party providers
are used! The high pressure hose and spray device must be
connected in a pressure-tight manner (without leakage).
The high pressure hose may not be driven over, pulled
excessively, or twisted. The hose may under no circum-
stances be pulled over sharp edges. Defective high-pressure
hoses must not be repaired (acc. to DIN 20022) but have to
be replaced by new hoses appoved by the
manufacturer.
Explanatory symbols affixed to the high-pressure cleaner
The high-pressure cleaner may only be operated in
horizontal position!
42
Ersatzteile auf www.gluesing.net
Operate high-pressure cleaner in horizontal position only.
Never direct the high-pressure jet at people or animals.
Never direct the water jet at power sockets or any other electrical
installations!