Idiomas disponibles
Idiomas disponibles
minimum clearance of 10 cm from any wall of the unit. Keep the unit away from any
hot surfaces. Always operate the unit on a level, stable, clean, fireproof and dry
surface and out of the reach of children and persons of impaired mental, sensory
and intellectual functions. Place the unit in such a way that the mains plug can be
reached at any time. Ensure that the power supply to the unit corresponds to that
specified on the identification plate!
3.3.
Working with the unit
3.3.1. Cumulation function
When the displayed value in weighing mode is positive and stable, press the [*] key
to cumulate the current weight and display the cumulated weight - the cumulation
indicator will be on. When this button is pressed again, it will return to the weighing
mode and the cumulation indicator will be turned off. Another cumulation
operation must be performed after the scale has been zeroed. When the cumulated
weight is displayed, press the [MODE] key to clear the cumulated weight from the
memory and press the [*] key to return to weighing mode. If it is necessary to check
the cumulated weight, reset the platform load and then press [*] to display the
accumulated weight.
3.3.2. Counting function
In weighing mode, press [MODE] to enter the counting mode. The display will show
"count. When pressing [*], it will display "C00000". Then press [TARE] to move the
digit which will be incremented by one each time after pressing the [ZERO] key. The
scale will enter the counting mode after entering the sample number and pressing
[*]. The display will show "0" and the counting light will come on. Press the [MODE]
key to return to weighing mode. After entering the counting mode, "count" will be
displayed. Press [*] twice to enter the counting mode directly and the indicator will
be displayed according to the last sampling result. (In this process, if ERR4 appears,
it means sampling has failed.)
3.3.3. Alarm setting
a) Setting the upper limit value (displaying the sign of the upper limit and the
upper limit value alternately by flashing) 0.000 - HH-
Press the [TARE] key to enter the number input - increase the value with
•
the [ZERO] key and press the [*] key to enter the lower limit value setting.
If it is not necessary to change the upper limit value, press the [*] key to
•
enter the lower limit setting.
Press the [*] button to exit directly from the setting.
•
•
If the upper limit value is set lower than the lower limit value, clear the
lower limit value.
