Idiomas disponibles
Idiomas disponibles
1. Assembling cleaner
This cleaner was inspected and packaged carefully before being shipped
from the factory. If you should happen to need assistance during assembly
or operation,
Visit us online at www.hoover.com to find the service outlet nearest
you (follow the service center link) OR
Call 1-800-944-9200 for an automated referral of authorized service
outlet locations (U.S. only) OR
Call 1-800-263-6376 to speak with a representative in the Hoover
Consumer Response Center.
Carton contents
1-1
A
Connect hose, wand and nozzle
A
1-2
B
D
C
Connect hose
Push the hose connector end (A) into the
opening (B) on the front of the cleaner,
making sure the prongs (C) on the hose
end align with the holes in the opening.
When hose end is properly inserted, you
will hear a click.
To disconnect hose from the cleaner,
press the button (D) on the hose con-
nector and pull straight out.
Note: The flexible hose contains
electrical wires for connection to the
power nozzle and should not be used
if damaged. The wires should not be
seen through the outer skin.
All manuals and user guides at all-guides.com
B
E
1-3
F
G
H
Attach wand and power
nozzle
Push the end of the wand with the but-
ton (E) firmly into the hose grip (F), mak-
ing sure the prongs (G) on the wand
align with the holes (H) in the hose grip.
When wand is properly inserted, you will
hear a click.
To remove the wand from the hose,
press on the button (E) located on the
end of the wand and pull straight out.
A second extension wand can be
attached in the same manner.
Unpack cleaner from carton and iden-
tify the parts shown. Remove and
dispose of cardboard packing.
C
A. Canister cleaner
B. Extension wands and hose
C. Power nozzle
D
D. Crevice tool
E. Round swivel brush
F. Upholstery tool
Operate cleaner only at voltage speci-
fied on data plate on bottom of
F
cleaner.
1-4
E
Push the opposite end of the wand into
the power nozzle (I), aligning the prongs
(J) on the power nozzle with the holes
(K) in the wand. When the power nozzle
is properly inserted, you will hear a click.
To remove the power nozzle, press on
the button (L) located on the power
nozzle and pull straight out.
I
J
K
L
Continued ➠
