Idiomas disponibles
Idiomas disponibles
Polaris
FREEDOM
Cordless Robotic Cleaner | Owner's Manual
®
™
Section 5. iAquaLink
Once you have downloaded the iAquaLink app and
connected the device to Wi-Fi, the iAquaLink app
allows for robotic cleaner control from anywhere,
anytime. Functions vary within the iAqualink app
depending on which cleaner model you have.
IMPORTANT
During cleaning cycles while in water, the cleaner will not have
connection to the WiFi. Once the cycle is complete place the cleaner
back on the charging stand to reconnect to the WiFi.
WARNING
Do not enter pool while the robotic cleaner is in water.
5.1
iAquaLink
Control Home Screen
®
App function and design is subject to change.
Start Cleaning
Clean Mode
Battery Charge Status
Green Charged: Ready
Green Charging: Ready
Yellow Charging
Yellow Partially Charged
5.2
Set Cleaning Mode
Start Cleaning
The factory default cleaning surface setting is
Floor/Wall.
1.
From the Home screen, press the Start button
to begin cleaning. The cleaner will turn off if it
is powered on but not submerged in water.
Control
®
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10 minutes). During this time,
the cleaner does not climb to the waterline.
2.
From the main screen, select Cleaning Mode
to view options.
3.
Select Cleaning Mode. The factory default
cleaning mode is Floor/Wall.
Cleaning Mode
Floor/Wall
Product or App
Floor
Product or App
SMART
Waterline
SMART Cycle
SMART Cycle calculates a customized cleaning
time optimized for your pool. On the first run of
SMART Cycle, the app counts up as it calculates
the optimized cleaning time.
On periodic SMART Cycle cleaning, the app will
count down from the optimized cleaning time.
NOTE: To Recalculate SMART Cycle, go to the Set
Cleaning Mode after the initial calculation.
5.3
In-App Error Messages and
Troubleshooting
If an error occurs, after removing the cleaner
from the water, the status bar will show a warning
symbol and: "Cleaning Interrupted".
1.
Click on the warning symbol to view
troubleshooting advice on how to fix the issue.
2.
Choose Clear Error if you believe you have
fixed the problem and want to re-try. Choose
OK if you want to suspend the cleaner in error
mode and work on the troubleshooting fix at a
later time.
5.4
System Settings
Access System Settings by pressing the gear icon
in the upper right hand corner of the app screen.
ENGLISH
Select
Runtime
2.5 hrs
1.5 hrs
In App
Calculated
In App
0:45 min
Page 13
