Idiomas disponibles
Idiomas disponibles
Polaris
FREEDOM
Cordless Robotic Cleaner | Owner's Manual
®
™
WARNING
DO NOT use an extension cord with the charging station
• Follow all charging instructions and do not charge outside of
the temperature range specified in the instructions. Charging
improperly or at temperatures outside of the specified range may
damage the battery and increase the risk of fire.
• When charging, cleaner must NOT be exposed to direct sunlight,
rain or inclement weather, heat ignition sources, pool and spa
chemicals or water. DO NOT position cleaner and charging
station on direct contact with soil.
• Charging station is outdoor-rated.
IMPORTANT
• Start the cleaner, then fully submerge in the water to start
cleaning cycle.
• At the end of each cycle, remove the cleaner from the pool
and recharge.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent basis.
The Polaris robotic cleaner includes a safety feature that automatically
stops the cleaner if it is powered on but not submerged in water.
For pools equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and back into the pool
when the impeller is out of the water.
3.1
Set Up and Charging
1.
Select a charging location (GFCI outlet) at
least 11.5 ft (3.5 m) away from the pool, out of
direct sunlight, rain or inclement weather, and
with adequate Wi-Fi strength.
Figure 5.
Charging Location
2.
Align the cleaner and charging station with
the wall for easier access to the controls and
handle.
3.
Plug charging station into GFCI.
4.
Seat cleaner on charging contacts.
The cleaner will "beep" and begin charging.
Figure 6.
NOTE: Battery LED will blink yellow when charging and
5.
6.
NOTE: For best results, dry the cleaner and base
3.2
1.
11.5 ft
(3.5 m)
Figure 7.
4 h
Plug in Charging Station and Seat
Cleaner
solid green when complete.
Fully charge the cleaner before every cleaning.
The battery LED will be solid green when
fully charged. Charging takes approximately
4 hours.
Check the current charge level in the App
whenever the cleaner is on the charging
station.
charging contacts before charging. Periodically
clean the charging contacts. See maintenance
section.
Start Cleaner
Select Cleaning Mode using the slider by
sliding and releasing to the left or by using
the App.
Cleaning Mode
Floor/Wall
Product or App
Floor
Product or App
SMART
Waterline
Slide and Release Left to Select Mode
ENGLISH
"BEEP"
Select
Runtime
2.5 hrs
1.5 hrs
In App
Calculated
In App
0:45 min
Page 9
