Charging The Flash Capacitor; Replacing The Flash Tube/Bulb - Metz mecastudio TL-300 Manual De Instrucciones

11.3 Charging the flash capacitor

The output of the studio flash unit is
reduced if the capacity of the flash capacitor
decreases.
This happens if the studio flash unit has only
been used with low flash output or has not
been used at all for an extended period of
time.
+
To achieve the optimum output of the studio
flash unit once again, you must fully charge
the flash capacitor for at least 30 minutes:
• Press power switch
Servo
• Press on the touchscreen.
3.0
k
OFF
• Press sensor button
Flash Power
6.0
• Once the button
• If you would like to use the studio flash unit
• Otherwise switch off the studio flash unit:
92
of the studio flash
unit so that it is in position (ON).
until the value 6.0
is displayed on touchscreen
lights up, leave
the studio flash unit switched on for
30 minutes.
after this, configure the desired flash
intensity using the button
Press the power switch of the studio
flash unit so that it is in position (Off).
.
.

11.4 Replacing the flash tube/bulb

Flash tubes/bulb are wearing parts that lose
their power after quite a few flashes and
have to be replaced.
Observe the following safety instructions
before and during replacement of the
flash tube/bulb because of a DANGER OF
ELECTRIC SHOCK, BURNS AND CUTS:
All maintenance work must be carried out
only with tools insulated in accordance with
IEC 60900.
First, discharge the capacitor of the studio
flash unit; to do so:
- move the power switch of the studio
flash unit to (ON).
- press the button to discharge the
capacitor by triggering the flash; then
immediately move the power switch
the studio flash unit to (OFF).
The power switch must be pressed within
half a second; otherwise, the capacitor
undergoes recharging.
- Remove the power plug from the outlet.
- After switching the unit off, wait one hour
before removing the flash tube.
of