Fulgor Milano F7IWC24O1-R Manual Del Usuario página 4

Idiomas disponibles

Idiomas disponibles

1. IMPORTANT INSTRUCTIONS FOR SAFETY AND THE ENVIRONMENT
EN
1.1 For your safety
>
If this appliance is replacing an existing appliance
which must be removed or disposed of, make
sure that it does not become a dangerous trap
for children by cutting its power supply cable and
rendering it impossible to close the door. Use the
same caution at the end of the lifespan of the new
appliance.
>
The appliance must be installed by following the
instructions in the Installation Guide, particular
care should be taken not to obstruct the vent
openings of the appliance and of the built-in units.
>
The appliance features a concentrated lighting
system with LED lamps. Do not stare into these
lamps when they are on to avoid possible eyesight
damage.
This warning is also contained on the label attached
to the inside of the refrigerator door.
>
Do not use any type of electrical equipment inside
of the food conservation compartments.
>
When positioning the shelves, do not place fingers
in the shelf slide guides.
>
Do not position containers of flammable liquids
near the appliance.
>
Completely switch off the appliance and unplug
the power supply cable during cleaning operations.
If the plug is not easily reached, it is a good idea to
turn off the breaker or remove the fuse that controls
the socket that the appliance is connected to.
>
The packaging material can be dangerous for
children: do not allow children to play with the
plastic bags, plastic film or Styrofoam.
>
Any repairs must be performed by a qualified
Fulgor Milano Service technician.
>
Do not damage the appliance refrigerant circuit
pipes.
>
Repairs may be performed by the manufacturer,
service company or a similarly qualified person
only.
>
Plug into a grounded 3 prong outlet.
>
Do not remove ground prong.
>
Do not use an adapter.
>
Do not use an extension cord.
>
Disconnect power to all units before servicing.
1.2 Important information when using
the appliance
>
Never use electrical appliances inside the
appliance (e.g. heater, electric ice maker, etc.).
Explosion hazard!
>
Never defrost or clean the appliance with a steam
cleaner! The steam may penetrate electrical parts
6
and cause a short-circuit. Risk of electric shock!
>
Do not use pointed and sharp-edged implements
to remove frost or layers of ice. You could damage
the refrigerant tubes. Leaking refrigerant may
cause eye injuries or ignite.
>
Do not store products which contain flammable
propellants (e.g. spray cans) or explosive substances
in the appliance.
Explosion hazard!
>
Do not stand on or lean heavily against base of
appliance, drawers or doors, etc.
>
Before cleaning the appliance, pull out the power
cord plug or switch off the breaker. Do not pull out
the power cord plug by tugging on the power cord.
>
Store high-percentage alcohol tightly closed and
standing up.
>
Keep plastic parts and the door seal free of oil and
grease. Otherwise, parts and door seal will become
porous.
>
Never cover or block the ventilation openings for
the appliance.
Symbols used in the Guide:
Note
Recommendations for correct use of the
appliance
Important
Directions for avoiding appliance damage
Warning
Indications for avoiding injury to people
1.3 Caring for the environment
>
Pay special attention to correct disposal procedure
for all the packaging materials.
>
The appliance must not be disposed of with urban
waste. Contact local waste disposal centers for on
how to dispose of recyclable waste.
>
Prior to disposal, cut the power supply cord and
remove the door.
>
During disposal, avoid damage to the refrigeration
circuit.
>
The appliance does not contain hazardous
substances for the atmospheric ozone layer, neither
in the refrigeration circuit nor in the insulation.
2.1 Installation
Make sure that installation is performed correctly,
adhering to all of the instructions in the specific
installation guide provided with the appliance.
2.2 Connection to electrical power
supply
The appliance operates at 115 V AC, 60 Hz and
is equipped with a power supply cord with a
3-prong grounded plug, which must be connected
to a corresponding 3-prong (15 Amp) grounding-
type wall receptacle.
Do not use extension cords and/or
multiple adapters for connection.
2. INSTALLATION
3.1 Know your appliance
Congratulations for having purchased your new
appliance: from now on you can use our innovative
conservation system, which will allow you to keep
wine in the best way possible.
This manual will answer most of your questions
about the product's features. Should you require
further information, please
>
call us 1-855-4FULGOR (1-855-438-5467)
>
visit fulgor-milano.com/us/en/assistance
Before calling, write down the model
code and serial number which are
available with the manuals and on the
rating plate located on the bottom left-
hand corner of the appliance, behind the
bottom drawer.
Before calling, please make sure to have the
following information ready:
- Date of Purchase;
- Name of dealer where product was purchased.
2.4 Refrigerant
The refrigerant isobutane (R600a) is contained
within the refrigerant circuit of the appliance, a
natural gas with a high level of environmental
compatibility, which is nevertheless flammable.
>
During transportation and installation of the
appliance, be certain that none of the components
of the refrigerant circuit become damaged.
>
If the refrigerant circuit should become damaged:
– avoid open flames and sources of ignition;
– thoroughly ventilate the room in which the
appliance is situated.
EN
EN
7
loading

Este manual también es adecuado para:

F7iwc24o1-lF7swc24s1-rF7swc24s1-l