Idiomas disponibles
Idiomas disponibles
8. WINE STORAGE
EN
8.5 Position of bottles
The sliding shelves are made of fine wood and
contoured so as to hold bottles of the most
classical traditional shape or of the most modern
design.
Whether your collection holds fine bottles or
small bottles they will be right at home in the
Fulgor Milano Wine Cellar.
Also Magnum bottles can be stored, provided
you remove the shelf just above the one that will
hold them.
After
a
prolonged
interruption
electrical power, once the electrical
power is reactivated, an audible signal
will indicate if the temperature has been
raised above normal levels. In addition to
this the display will show for one minute
the highest temperature detected inside
the compartments, to allow the user to
decide how to better use the food items.
After one minute the display will resume
normal operation, while the Alarm button
will continue to blink.
Press the Alarm button
to display the
highest recorded temperatures.
Bordeaux
Burgundy
BOTTLE
BOTTLE
28
9. CARE AND CLEANING
9.1 Care and Cleaning
To clean the parts made of steel use a microfiber
cloth and the sponge provided in the kit with the
appliance. Always use the cloth and sponge in
the direction of the steel's satin finish.
Every now and then, to polish the steel, wipe
with a slightly damp microfiber cloth.
You should use special care to keep the
ventilation openings in the appliance or in the
cabinet that houses it free of obstructions.
of
Carefully follow the detailed directions
that can be found in the provided kit and
never use abrasive or metallic products
which could scratch and damage the satin
finishing on the appliance permanently.
Before performing any sort of cleaning,
disconnect
the
appliance
from
electrical power supply.
Make sure you do not damage the
refrigerant circuit in any way.
Do not use chlorine-based detergents or
cleaning agents.
9.2 Cleaning of the ventilation grille and
condenser.
The unit requires, for a correct operation, the
cleaning of the toe kick cover, filter and
condenser.
It is recommended to perform the following cleaning
steps very 12 months. If enabled, an audio and visual
message on the display will serve as a reminder. It
is possible to disable the warning signal and see the
time left before the next cleaning has to be done.
Behind the frontal ventilation grille is the condenser.
To clean it use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along in
the direction of the vent slits. In case of a significant
dust build up, the toe kick cover can be removed
to allow a more accurate cleaning of the filter.
On the mantenience settings,
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign is enabled, there will
be an audible signal every 12 months, alerting that
the
it is time to clean the condenser.
After cleaning it, touch the reset icon in order to
reactivate the warning signal in 12 months.
If you do not want the cleaning signal alert for the
condenser, touch the Off icon.
Lower condenser.
For cleaning the condenser follow the
instructions:
>
Remove the magnetic grille behind the door.
MAINTENANCE
SERVICE
after the
INFORMATION
>
Clean it thoroughly of any dust build up as shown
in the picture, taking care not to damage the
condenser.
The edges of the condenser are extremely
thin and can be sharp, therefore use
adequate protection for hands and arms
when cleaning the condenser.
EN
29
