Idiomas disponibles
Idiomas disponibles
1)
Empty and dry the water tank, and then install it back.
2)
Clean the filter.
3)
Place the appliance upright and avoid the direct sunlight.
Filter
There is a filter set at the back of the appliance that must be removed and cleaned regularly. The dehumidifying
capacity may reduce when the filter set is clogged.
•
Pull the tab (A) to detach the filter case (B). Take off the filter net (C) and then take out the activated carbon
filter (D).
•
The filter case and filter net can be washed in water (temperature < 40°C). Dry them well before assembly.
•
The activated carbon filter cannot be cleaned in water. You may use a vacuum cleaner to remove the dust.
It is recommended that the activated carbon filter is replaced every 3-6 months (depending on usage) to ensure
peak performance of the appliance.
TROUBLE SHOOTING
Problem
No working
Small
dehumidifying
capacity
Big noises
Stop
during
the
dehumidifying process
The clothing cannot be
dried fast.
Possible Cause
The power plug is not connected.
The water tank is full.
The water tank is not positioned
properly.
The air outlet cover is not open.
The filter is clogged.
The air inlet or air outlet is
obstructed.
The appliance is not placed well.
The room temperature is beyond the
working scope of the appliance.
The clothing is not exposed to the air
sent from the appliance.
The room temperature is too low.
Solution
Plug in.
Empty the water tank.
Place it well.
Open the air outlet cover.
Clean the filter.
Remove the obstruction from the air outlet
or air inlet.
Place the appliance on a smooth and stable
floor.
The appliance may start automatically when
the room temperature returns to the
working scope 5℃ - 32℃.
Try to expose the wet clothing to the air
flow.
The wet clothing may dry more slowly in low
temperature. Try to raise the room
temperature.
- 11 -
