Idiomas disponibles
Idiomas disponibles
ENGLISH
6.2
Start / Stop Cleaning and Adjust
Cleaning Time
The factory default cleaning surface setting is
SMART Cycle (Floor, Wall, Waterline).
SMART Cycle calculates a customized cleaning
time optimized for your pool. On the first run of
SMART Cycle, the app counts up as it calculates
the optimized cleaning time.
On periodic SMART Cycle cleaning, the app will
count down from the optimized cleaning time.
NOTE: To Recalculate SMART Cycle, go to the Set
Cleaning Mode after the initial calculation.
1.
From the Home screen or the control box,
press the Start button to begin cleaning.
2.
The app displays the cycle time in hours and
minutes.
To increase or decrease the cycle time during
cleaning, press the (+) and (–) buttons.
— Time adjusts up or down in 15 minute
increments.
— Minimum run time is 30 minutes.
— Maximum run time is 3 hours 30 minutes.
— The control box displays the same
countdown and cycle setting as the app.
3.
Press
to interrupt and cancel an
in-progress cleaning cycle.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10 minutes). During this time, the
cleaner does not climb to the waterline.
6.3
Set Cleaning Mode
1.
From the main screen, select Cleaning Mode
to view options.
2.
Choose from available cleaning modes
depending on your cleaner model.*
3.
In Custom mode (if applicable), select the
cleaning surface and cleaning intensity from
the on-screen icons.
*not available on all models
Page 12
Polaris
6.4
Remote Control
Use your mobile device as a remote control.
IMPORTANT
Only use remote control when in view of the cleaner.
1.
From the main screen, select the Remote tab.
NOTE: When in remote control mode, the control box
displays
2.
You can direct the cleaner using the remote
control or use the spot clean feature to help
pick up debris.*
3.
To use "Spot Clean" drive the cleaner near
where debris has collected and initiate "Spot
Clean." The Cleaner will perform a short
cleaning pattern to remove debris in that area.
*not available on all models
NOTE: If you experience significant delays between the
app command and cleaner response, you may
have a weak Wi-Fi signal or other connectivity
challenges that interfere with the immediacy of
the remote control functions.
6.5
Lift System
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be
activated at any time during or after a cleaning
cycle.
IMPORTANT
Only use Lift System when in view of the cleaner.
1.
From the home screen, select Lift System
to enter automated procedure.
2.
Use the left and right controls to rotate the
cleaner to face the wall of your choice.
3.
Press the Lift System icon to drive the cleaner
up the wall it is facing. The cleaner will wait at
the water line to be retrieved.
NOTE: To stop the procedure at any time, press and
release the button again.
4.
When in reach, grab the cleaner handle and
begin to pull cleaner out of the water. The
cleaner will quickly expel water to allow for
lighter, easier removal.
NOTE: Never lift the cleaner out of the pool by the
floating cable.
Robotic Pool Cleaner | Owner's Manual
®
.
