Stopping The Cleaner And Removing From The Pool; Cleaning And Storing The Cleaner - Polaris 9400 Sport 4WD El Manual Del Propietario

4.3 Stopping the Cleaner
and Removing from the Pool
The automated Lift System makes removing the cleaner
from the pool easier. The Lift System will raise the
cleaner to the surface and move it toward the edge of
the pool.
1. At the end of the cleaning cycle, or at any time
during a cleaning cycle, press
the automated lift procedure.
Press and release the Lift System button to raise
the cleaner to the water line.
Press and hold the Lift System button to turn
cleaner to the left. Cleaner will keep moving
left until you release the button.
The screen displays
Lift System is in operation.
NOTE: To stop the lift procedure at any time, press
2. When the cleaner is within arm's reach,
handle to remove from the water
18). Never lift the cleaner out of the pool by the
floating cable.
Figure 17. Remove Cleaner From Pool wth handle
Figure 18. keep Cleaner Vertical to Drain Water
to begin
when the
use the
(Figures 17,
1
2
3
The 9400 4WD / P94 4WD includes a safety feature that
automatically stops the cleaner after about 20 seconds if
it is powered on but not submerged in water. For pools
equipped with a beach area, this safety feature allows
the cleaner to reverse, and back into the pool when the
impeller is out of the water.
4.4

Cleaning and Storing the Cleaner

The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as
trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your cleaner
dry in direct sunlight near the pool. The cleaner must be
stored on its caddy so that it dries quickly.
1. Place the rear wheels on the caddy side wedges.
2. Place cleaner in vertical position on the caddy
base and clip to hook (Figure 19).
3. Disconnect the cable from the control unit.
Replace the protective cap on the control unit.
.
4. Loosely coil the power cable starting at the
cleaner and moving toward the connection point
at control unit. Remove any twists along the
way. Store the cable by wrapping it around the
hook located on the front of the caddy
(Figure 19).
Figure 19. Cleaner Correctly Stored on Caddy
Page 11