Idiomas disponibles
Idiomas disponibles
Category
Parameter
ADCC
DHCP disabled
IP address
Network Mask
Gateway
Host name
Category
Parameter
Remote
IP address
System
Port No
Output
Communication
Results
(ASTM/HL7 only)
PAT/QC
(ASTM/HL7 only)
Configuration
□
When using fixed IP address, the DHCP has to be disabled
Please insert the fixed IP address [0-255/0-255/0-255/1-254]
Please insert the network mask for the ADCC box
[0-255/0-255/0-255/0-255]
Please insert the gateway [0-255/0-255/0-255/1-254]
Valid characters for hostname are [A-Z], [0-9], [-]. The Hostname
length can be from 1 -16 characters
Configuration
Insert the IP address of the receiving system
[0-255 0-255 0-255 1-254]
[0-65535] (0 = not set)
ASTM Low Level: For relevant information, see chapter 11.
The communication protocol is based on ASTM E 1381 - 95
ASTM High Level: For relevant information, see chapter 11.
The communication protocol is based on ASTM E 1394 - 97
HL7: For relevant information, see chapter 11. The communication
protocol is based on HL7 version 2.4
POCT1-A: For relevant information, see chapter 11. The
communication protocol is based on NCCLS: Point-of-Care
Connectivity; Approved Standard. NCCLS document POCT1-A.
New Results Only: Only test results obtained after first connection
between ADCC and Alere Afinion AS100 Analyzer will be transferred
to the EPR system
All Results: All results stored in the Alere Afinion AS100 Analyzer
memory and future test results obtained after first connection
between ADCC and Alere Afinion AS100 Analyzer will be transferred
to the EPR system
If the ADCC has been connected to the Analyzer before,
only results after last connection will be transferred. To send
all results again the Clear device list must be used. See the
category Reset
Only Patient: Only Patient results will be transferred to the EPR
system
Patient and QC: Patient and Control results will be transferred to the
EPR system
Alere Afinion
Data Connectivity Converter
™
EN
US
5
