Stihl FS 90 Manual De Instrucciones página 25

4
3
5
6
7
Fit the clamp (3) in the loop
N
handle (4) and place them both on
the drive tube (5).
Place the clamp (6) in position.
N
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) and tighten
N
them down moderately against the
barrier bar.
Go to "Securing the loop handle".
N
FS 90, FS 90 R
Loop handle without barrier bar
2
Fit the clamp (3) in the loop
N
handle (4) and place them both on
the drive tube (5).
Place the clamp (6) in position.
N
Line up the holes.
N
Fit washers (7) on the screws (8)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the loop handle".
N
8
8
7
7
4
3
5
6
1
1
Securing the loop handle
A
9
10
Secure the loop handle (4) about
N
20cm/8in (A) forward of the control
handle (9).
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
English
4
23