Stihl FS 90 Manual De Instrucciones página 23

Remove the tommy screw –
N
washer (6) remains on the tommy
screw
Separate clamps – springs (4, 5)
N
remain in the lower clamp!
Fastening the handlebar
7
Position the handlebar (7) in the
N
lower clamp (1) so that distance (A)
is not more than 6 in. (15 cm)
Place the upper clamp on top and
N
hold both clamps together
Insert the tommy screw with the
N
washer on it through both clamps as
far as it will go – hold all parts
together and secure them
FS 90, FS 90 R
A
1
Position the entire secured
N
assembly on the handlebar
support (8) with the tommy screw
facing the motor
Press the tommy screw into the
N
handlebar support as far as it will go
and then screw it in – do not tighten
it down yet
Align the handlebar so that it is
N
perpendicular to the shaft – check
distance (A)
Tighten tommy screw N
8
Attaching the control handle
Unscrew the bolt (9) – the nut (10)
N
remains in the control handle (11)
Push the control handle with the
N
throttle trigger (12) facing toward
the gearbox onto the end of the
handlebar (7) until the holes (13)
align
Screw in and tighten the bolt (9)
N
Fastening the throttle cable
Do not kink the throttle cable or
run it in tight radiuses – the
throttle trigger must move freely!
English
21