GYS WF 50 Manual De Uso página 30

User manual
PROCESS SETTINGS
Welding current
Access to some interface functions is not available in Gouge mode (JOB, etc.).
OPTIONAL PUSH-PULL TORCH
Reference Wire diameter
038738 0.8 > 1.2 mm
038141 0.8 > 1.2 mm
038745 0.8 > 1.6 mm
A Push-Pull torch can be connected to the wire feeder via an optional interconnection cable (II-6). This type of torch allows the use of AlSi wire even
in Ø 0.8 mm with a torch length of 8 m. This torch can be used in all MIG-MAG welding modes.
The Push-Pull torch is detected by simply pulling the trigger.
When using a push-pull torch with potentiometer, the highest control range setting can be set using the interface.
The potentiometer can then range anywhere between 50% and 100% within this setting.
OPTIONAL ROLLERS (F)
Diameter
Steel
ø 0.6/0.8 061859
ø 0.8/1.0 061866
ø 1.0/1.2 061873
ø 1.2/1.6 061880
If the rollers are worn, or if the filler wire used has a diameter > 1.6mm, it is advisable to replace the plastic wire guide:
Diameter Colour
ø 0.6>1.6 blue
ø 1.8>2.8 red
OPTIONAL FLOWMETER KIT
OPTIONAL TROLLEY
075498
30
Translation of the original
instructions
Units
The welding current is determined by the diameter and type of gouging electrode (max. 400 A).
A
(refer to the electrode packaging).
Length
8 m
8 m
8 m
Reference (x4)
Aluminum
-
061897
061903
061910
Reference
061965
061972
The flow meter kit (ref. 073395) allows for precise adjustment and control of the gas flow from the torch,
when connected to a gas supply. The gas pressure in the system must be stable and between 2 and 7
bar. The flow rate can be set between 3 and 30 l/min.
Cooling type
Air
Liquid
Liquid
Reference (x4)
Diameter
Flux-cored wire
ø 0.9/1.1 061927
ø 1.2/1.6 061934
ø 1.4/2.0 061941
ø 1.6/2.4 061958
WF 50