Error Codes - GYS WF 50 Manual De Uso

From a list of previously created JOBs, JOB recalls are done by short trigger presses. All trigger modes and welding
modes are supported.
1- New - Creating a QuickLoad
• Customise the name of the QuickLoad by pressing push-button no. 3 ( ).
• Choose the number of jobs to be recalled, between 2 and 20.
• Choose the trigger sensitivity: slow, normal or fast
• Choice of Jobs to be recalled (max 20)
Press push-button no. 4 to confirm (
Display the current QuickLoad
At the bottom right of the screen, the QuickLoad number is displayed.
Stopping the QuickLoad in progress
To close the current QuickLoad, the user must return to the Job/QuickLoad menu and select «Close».
2- Open - QuickLoad management
The left-hand side of the screen lists previously created QuickLoads.
Short presssing push-button no. 1 returns to the previous menu
A short press on the push-button no. 2 allows to sort QuickLoads by name or by date.
Holding down on push-button no. 2 ( ) deletes the selected QuickLoad or all QuickLoads.
A short press on push-button no. 3 ( ) allows the selected QuickLoad to be changed.
The right-hand side of the screen shows the details of all previously created QuickLoads.
A short press on push-button no. 3 (
A short press on push-button no. 3 ( ) changes the active QuickLoad.
A short press on push-button no. 4 (

Error codes

The following table shows a non-exhaustive list of messages and error codes that may appear.
Carry out these checks and inspections before calling in an authorised GYS technician.
If the user needs to open the product, they must turn off the power supply by disconnecting the electrical plug from the socket, and
wait two minutes for safety.
Codes
error
OVER-VOLTAGE FAULT
001
Check the electrical installation
UNDER-VOLTAGE FAULT
002
Check the electrical installation
005 Earth current fault
COOLING UNIT FAULT
006
Cooling unit not detected
FLOW ERROR
007
Cooling circuit blocked
WATER LEVEL ERROR
008
Check the coolant level
) the creation of a QuickLoad.
) creates a new traceability.
) loads the active QuickLoad.
Messages Solutions
Have your mains supply checked by an authorised person.
Presence of a stray current. Check the cabling of the welding acces-
sories (torch, ground clamp, electrode holder, etc.)
The cooling unit is no longer being detected. Check the connection
between the cooling unit and the power source.
Check the continuity of the torch's coolant flow.
Check the fuse of the cooling unit.
Fill the tank of the cooling unit to the maximum (recommended coo-
lant: ref. 062511)
23