Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing and Removing Attachments
WARNING: Ensure LEDs are off and the system is not on.
Blender (Fig. C)
1. To install, slide the immersion blender attachment
the motor
6
and turn clockwise (as viewed from the end of
the attachment) until it securely locks in.
2. To remove, turn counterclockwise and pull attachment off.
Food Chopper (Fig. D)
•
To attach, slide the motor
It does not lock into the unit, but ensure the unit is fully
seated into the attachment. Do not operate if unit is
slightly raised out of attachment.
•
To remove, turn off the unit and allow the blade to stop,
then lift the unit off of the food chopper.
hand Mixer (Fig. E)
1. To install, slide the straight beater
adaptor hole
33
of the hand mixer adaptor
clicks into place and is secure.
2. Slide the ring beater
32
it clicks into place and is secure.
3. Slide the hand mixer adaptor
and turn clockwise (as viewed from the end of the
attachment) until it locks in securely.
4. To remove, turn adaptor counterclockwise and pull it off,
then pull the beaters from the adaptor.
Whisk (Fig. F)
1. To install, slide the whisk pole
hole
38
until it clicks into place and is secure.
2. Slide the whisk adaptor
clockwise (as viewed from the end of the attachment)
until it locks in securely.
3. To remove, turn adaptor counterclockwise and pull it off,
then pull the whisk from the adaptor.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and keep hands away from
the switch before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
On / Off (Fig. G)
iMPORTAnT: Never turn the motor on unless attachments
are securely attached.
nOTE: Optimal temperature for use is between 50–104 °F
(10–40 °C).
1. To turn unit on, either:
‑
Press unlock button
‑
Press power button, then press unlock button.
‑
Press unlock and power buttons simultaneously.
nOTE: There is a slight delay between pressing both buttons
and the appliance starting.
2. When the appliance is ready to use, the LEDs
illuminate and remain solid. If they do not, refer to the
Troubleshooting section.
6
into the food chopper lid
31
into the small
30
into the large adaptor hole
30
onto the motor
36
into the whisk adaptor
37
onto the motor
6
and turn
2
, then press power button
5
will
nOTE: If LEDs go off during use, or don't light when starting
unit, release buttons and go back to step 1.
3. Once the unit is on, the buttons may be released for up to
5 seconds. The motor will stop running after the buttons
are released but the appliance remains active for 5 seconds.
14
onto
As long as the power button is pressed at least once within
5 seconds after releasing, the appliance will turn back on.
4. To turn off, release both buttons. The appliance will
remain active for 5 seconds before turning off.
WARNING: The LEDs will stay on after buttons are
21
.
released. Ensure the LEDs are off and the unit has fully
stopped before removing attachments.
Speed Control (Fig. H)
The appliance has a variable‑speed dial
the appropriate speed for the attachment being used (1 is
the lowest speed, 5 is the highest speed).
ATTACHMENT
until it
Immersion Blender
Food Chopper
34
until
Hand Mixer
6
Whisk
nOTE: With a 5‑second delay before the unit turns off, you
can release the buttons and use your thumb to adjust speed
without turning the unit off.
Proper Hand Position (Fig. I)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Hold the appliance
button
2
and use your thumb or a finger to push down the
power button
IMMERSION BLENDER
Intended Use
This immersion blender is intended for residential use only.
It blends liquids such as sauce, soup, and smoothies, mixes
batters, and purees fruits and vegetables.
DO nOT let children come into contact with the appliance.
3
.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and keep away from the
power button before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
SPEED
Start at 1, increase as needed
Start at 1, increase as needed
Start at 1, increase as needed
Start at 1, increase as needed
1
so your palm presses down the unlock
3
.
BCKM101MB
English
4
. Turn the dial to
11
Tabla de contenido
