Zzipp ZZBUBBLE Manual De Ususario página 5

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

RIGGING
We recommends using the following general guidelines when mounting this product.
Before deciding on a location for the product, make sure there is easy access to the
product for maintenance and programming purposes.
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the Technical Specifications).
When mounting the product on the floor, make sure that the product and cables are
away from people and vehicles.
OPERATION
Preparing for Operation
After checking that all the parts are intact and complete, position the machine on
flat. Withdraw the fluid tank from its compartment and remove its cap.
Verify that the plastic hoses attached to the cap are in place and in good condition
without bending orwarp.
Always connect the product to a grounded circuit. Before power on, make sure it is
connected with the rated voltage.
Turn on the machine, and " Heating up" shows on the display during the heating —
up process.
After approx. 3 minutes, the display changes to "Ready to work" when the machine
is ready to output.
OPERATION
To access the control panel functions, use the four buttons located underneath the LCD display.
MENU:
Switch menu pages to select a function
Increases the numeric value of current function
TIMER:
Triggers Timer output mode
Decreases the numeric value of current function
FOG:
Triggers Manual output mode.
Save settings
STOP:
STOP turns the fog & bubble output off
5
Tabla de contenido
loading

Tabla de contenido