Trust SWITCH-IN START-LINE ACM-2300-HC Manual Del Usuario página 9

6B. This is the technical installation schematic of the ACM-2300-HC with two wall-switches (hotel/
stairwell circuit).
6C. This is the technical installation schematic of the ACM-2300-HC with one wall-switch.
7. Installation behind an existing wall switch
Take note how the existing wires are connected and disconnect the wall switch.
• Connect the switch wire (black) from the wall box to the [
• Connect the live wire (brown) to a terminal block.
• Connect a new live wire (brown) from the terminal block to the L contact.
• Connect a new live wire (brown) from the terminal block to the wall switch (in the place where the
live wire (brown) was previously placed)
• Connect a (blue) neutral wire to the left [N] contact. If there is no neutral wire present, it must be
pulled. Consult an electrician if in doubt.
• Connect a new black switch wire to the S contact and connect it to the wall switch (in the place
where the black switch wire was previously placed)
8A Enable mains power
Switch the mains power ON before proceeding with the installation.
Make sure no stripped parts of wires are touched after this step.
The LED indicator on the receiver will light up for a few seconds when voltage is applied.
8B. Activate pairing mode
Press for about 1 second (with a pointed object) on the Connect button to activate the pairing mode.
The pairing mode will be active for 12 seconds and the LED indicator on the receiver will flash slowly.
8C. Send an ON signal
While the LED indicator flashes, press the ON button on a Trust Smart Home transmitter to pair the
transmitter to the ACM-2300-HC. (Or activate a Trust Smart Home sensor).
9. Pairing confirmation
ACM-2300-HC BUILD-IN SWITCH
] terminal.
L L
EN
9