Trust SWITCH-IN START-LINE ACM-2300-HC Manual Del Usuario página 11

Deleting a single transmitter code
Press for about 1 second on the Connect button. The pairing mode will be active for 12 seconds and
A
the LED indicator on the receiver will flash slowly.
Send while the pairing mode is active with the connected Trust Smart Home transmitter an
B
OFF signal. If necessary, consult the instruction manual of the transmitter.
The LED on the module will flash to confirm that the code has been removed.
C
Repeat this procedure to delete several transmitters from the receiver.
Erase entire memory
Press the Connect button for about 8 seconds until the LED indicator flashes quickly.
A
When the LED indicator flashes rapidly, press the Connect button again shortly to confirm that you
B
want to completely erase the memory.
The LED on the module flashes to confirm that the memory has been erased.
C
ACM-2300-HC BUILD-IN SWITCH
EN
11