Herschel HS220UD Instrucciones De Instalación Y Funcionamiento página 5

Setup
Select under desk heater
1. Find the two feet supplied in the
package.
2. Fit to the long lower side of the heater.
The SMART-R power box at the back of
the panel should be at the bottom edge
of the heater.
3. Use a screw driver to tighten the friction
screws against the rear surface of the
heater. (Note: tightening the screws
against the front will damage the front
surface of the heater).
The Select under desk heater comes with a
factory fitted plug and can be plugged into
an available socket under the desk.
The SMART-R receiver allows your under
desk heater to operate in two different ways
according to preference:
• It can act in a simple "on / off" mode
using the foot control;
• It can connect to wifi and be managed via
the SmartLife App.
Controls on the SMART-R receiver are as
follows:
1. LED display showing
temperature
2. Wifi indicator
3. Timer On/Off indicator
4. On / Off button
5. Manual pairing button
6. Manual Temperature Increase
7. Manual Temperature Decrease
8. Built-in Thermostat.
downwards to sense the temperature
around the heater.
9. Power Switch (I = On, O = Off)
10. Mains cable
11. Foot Switch.
ENGLISH
setpoint
Pull gently