Assembly And Operation - Metabo HPT G 3612DVE Instrucciones De Seguridad Y Manual De Instrucciones

Electric control
○ Soft-start
○ Kickback Protection
The kickback protection feature cuts off the power
to the motor and stops the power tool in the event of
a sudden drop in the rotational speed of the wheel
during operation (for example, if the wheel locks
during cutting operation, etc.).
○ Overload protection
While working, if a load exceeding a certain level is
applied, or if the grinding disc is stopped for a certain
amount of time, the motor will be stopped to protect
the tool and for safety.
Turn off the switch once, then turn it on again to start
up the tool.
○ Rotation recovery control function
While working, if the tool is pressed too forcefully
against the surface and the motor stops, if you lift up
the tool and lighten the load, rotation will resume.
Depending on the grinding disc used and the working
conditions, the rotation recovery control may be
stopped by overload protection.
CAUTION
When using ET36A, this function does not
operate.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various type of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means
of an acetylene torch.
○ Grinding of synthetic resins, slate, brick, marble.
WARNING
To avoid the risk of serious injury, NEVER use
this grinder with cup wheels and/or saw blades.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 5).
CAUTION
Never short-circuit the battery.

ASSEMBLY AND OPERATION

○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in
a few minutes.
After that you can use it again.
○ Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can
be canceled once the tool is switched off .
○ Brake function
Brake activates when the switch is off.
CAUTION
When using ET36A, this function does not
operate.
○ Drop shut off function <G3612DVE>
When the drop shut off function has been activated,
the motor may stop.
In this case, release the tool switch.
After that you can use it again.
2. Battery installation
Insert the battery while observing its polarities
(see Fig. 5).
Latch
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
English
Pull out
Insert
Push
Battery
Fig. 5
13