Metabo HPT G 3612DVE Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
10. About the mode change function (Fig. 13)
The unit has "Transmission mode" and "Auto mode".
The mode can be switched by pressing the Auto
mode switch.
Adjust the number of revolutions in Transmission
mode using the dial, while referring to the table below.
○ With Transmission mode, the grinder's number of
revolutions can be set at one of six stages.
When operating in Transmission mode, the set
number of revolutions will be maintained regardless
of changes in load.
○ With Auto mode, you can lower noise and vibration by
lowering the maximum number of revolutions while in
a no-load state.
While in Auto mode, the number of revolutions will be
raised if the load becomes greater during operation.
On the other hand, the number of revolutions will
be lowered if the load decreases during operation.
(Table 6)
○ Set the mode and dial according to work application.
Dial
Auto mode switch
18
Switch panel
Fig. 13
Number of
Revolutions (/min)
Status
G3612DVE G3615DVF
G3612DVF
1 3,200
2 3,900
3 5,300
4 7,400
5 8,600
6 10,000
Auto L 5,500
Auto H 10,000
Auto L: No-load
Auto H: During operation
11. How to use the LED light
By pressing the lighting mode switch on the switch
panel, the LED light mode changes as Table 7. It is
indicated by green lamp. (Fig. 14)
To prevent the battery power consumption, turn off the
LED light frequently.
LED light (both sides)
Switch panel
Lighting mode switch
Table 6
Use
Grinding
3,200
stainless steel
Rust or paint
3,600
removal
Grinding,
4,600
fi nishing
5,600
Rough
7,200 grinding,
cutting
8,000
Light work,
5,500
Standby state
Grinding, cutting
8,000
Switch
Lighting mode
indicator lamp
Fig. 14