Operation - cecotec BOLERO AGUAZERO COOLMARKET 1D 242 WHITE Manual De Instrucciones

ENGLISH
Fig. 6 key
8. Screw gap cover
9. Upper right hinge cover
3. Loosen the plate self-tapping screws (11) used to fix the upper hinge (10) with a screwdriver
or an 8-mm wrench (6) (hold the door while you do this step). Fig. 7
Fig. 7 key
10. Upper hinge
11. Plate self-tapping screws
4. Remove the upper hinge shaft (12), move it to the left side and tighten it firmly, as shown in
figure 8. Next, keep the upper hinge in a safe place for later use. Fig. 8
Fig. 8 key
12. Upper hinge shaft
5. Remove the door from the lower hinge in the direction shown in the figure.
Note
When removing the door, be careful with the lower hinge, as it may get stuck on the door. Do
not lose it. Fig. 9
6. Place the door on a soft surface with the interior facing down. Loosen the screw (14) and the
stop (13) on the lower right corner of the door, and insert them on the left side. Fig. 10
Fig. 10 key
13. Stop
14. Self-tapping screw
7. Place the refrigerator on soft foam packing material or a similar material. Remove the
adjustable lower feet parts (16) and the lower right hinge (15) by loosening the plate self-
tapping screws (17). Fig. 11
Fig. 11 key
15. Lower hinge
16. Adjustable lower feet part
17. Plate self-tapping screws
8. Place the lower hinge again (15) on the left side and fix it with the plate self-tapping screws
(17). Place the adjustable lower feet parts again (16) on the other side and fix them. Fig. 12
9. Place the door on the left side, adjust the lower hinge (15), insert the hinge shaft on the lower
gap of the door. Fig. 13
56
10. Place the upper hinge (10) and insert the upper hinge shaft (12) on the upper gap of the door,
and adjust the door position (hold the door during this step) by fixing the upper hinge (10) with
the plate self-tapping screws (11). Fig. 14
Fig. 14 key
10. Upper hinge
11. Plate self-tapping screws
11. Install the screw gap cover (8) on the upper right corner of the refrigerator. Install the upper
left hinge cover (7) (included in the plastic bag) on the left corner. Place the upper right hinge
cover (9) in the plastic bag. Fig. 15
Fig. 15 key
7. Upper left hinge cover
8. Screw gap cover
12. Change the handle on the left side of the door to the right side as shown in figure 16.
13. Open the door and assemble the shelves.

4. OPERATION

Start-up and temperature control
After installing the refrigerator, wait for at least 5 minutes and plug it to a power socket. Do not
store anything on it until the interior temperature is low enough to do so.
When you open the door, the interior light will turn on.
Control panel. Fig. 17
Level 0: refrigerator off. Turn the knob clockwise to turn the refrigerator on.
Level 1: highest temperature setting.
Level 7: lowest temperature setting.
It is advisable to use the medium temperature settings, that is, levels 2, 3 or 4. However, you
must always set the temperature level according to your needs, knowing that the lowest
temperature helps preserve food and the highest temperature leads to food waste.
Compartment Temperature range (ºC)
Refrigerator 2-8
ENGLISH
Suitable food
Eggs, cooked food, packed
food, fruits and vegetables,
dairy products, cakes, drinks
and other food which are not
suitable for freezing.
57
COOLMARKET 1D 242 WHITE