Before Use; Operation; Cleaning And Maintenance - cecotec GrandCooler 10000 Manual De Instrucciones

ENGLISH

3. BEFORE USE

• Take the product out of the box and remove all packaging materials.
• Make sure the product is in good conditions. If any visible signs of damage are observed,
contact the Technical Support Service of Cecotec immediately.
• Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a surface that is strong enough to support the appliance when it
is fully loaded. To level your appliance, adjust the front legs at the bottom of the appliance.

4. OPERATION

Warning: Make sure the supply cord is not trapped, tangled or damaged before operating the
device.
For an optimal operating as well as energy consumption, it is recommended to install the
appliance in a place where room temperature is between 16-25°C.
Setting temperature
• The inside temperature can be adjusted by
rotating the knob, which is located inside the
appliance.
1. Light switch
2. Temperature knob
3. LED light
• There are 7 different levels: 1 is the highest
temperature (warmer), 7 is the lowest (colder).
• Use the light switch inside the appliance to turn on or off the inside light.
Note: For the first use, set temperature to level 7 for the appliance to cool faster.

5. CLEANING AND MAINTENANCE

•
Disconnect the appliance from the power supply and remove all contents inside it before
cleaning.
• Clean regularly the inside of the appliance with warm water and baking soda solution. The
solution should be about 2 tablespoons of baking soda to a quart of water.
26 GRANDCOOLER 10000 SILENT