Parts And Components; Before Use; Installation - cecotec BOLERO AGUAZERO COOLMARKET 1D 242 WHITE Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Control panel and LED light
2. Refrigerator shelves
3. Crisper drawer cover
4. Crisper drawer
5. Adjustable lower feet
6. Handle
7.
Door top shelves
8. Door lower shelf
9. Door
Note
The graphics in this manual are schematic representations and may not exactly match the
product.
To make the most out of the refrigerator in terms of energy, place all the shelves and drawers
in their original position, that is, as shown in figure 1.

2. BEFORE USE

This product includes a packaging designed to protect it during transport. Take the refrigerator
out of the box. You can keep the original box and other elements in a safe place, this will help
you prevent product damage when transporting it in the future. In case the original packaging
is disposed of, make sure all packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any piece
missing or not in good condition, immediately contact the Technical Support Service of Cecotec.
Box contents:
Bolero CoolMarket 1D 242 White refrigerator
Instruction manual

3. INSTALLATION

Warning:
For proper installation, the refrigerator must be placed on a levelled surface of hard material
that is at the same height as the rest of the floor. This surface must be strong enough to
withstand a completely loaded refrigerator.
54
Refrigerator ventilation. Fig. 2
To improve the refrigerator system efficiency and to save energy, it is necessary to ensure a
proper ventilation around the refrigerator to dissipate the heat. For this reason, you should
leave enough free space around the refrigerator.
It is advisable to leave at least 50-70 mm of free space from the rear part of the refrigerator to
the wall, at least 100 mm space from the surface to the ceiling, at least 100 mm from the side
to the wall and a free space in the front part to be able to open the door at 135º. Check figure
2 for reference.
Refrigerator stabilisation
For sufficient stabilisation and air circulation at the lower rear part of the refrigerator, it may be
necessary to adjust the lower feet. You can adjust them manually or using a suitable wrench.
To allow the doors to close automatically, tilt the upper part back by about 10 mm as shown
in figure 3.
Changing the opening direction of the door
If desired, you can change the direction in which the door opens, from the right side (by default)
to the left side.
Warning
The refrigerator must not be connected to the power socket when you change the opening
direction of the door. Make sure to disconnect the plug from the power socket.
Check figure 4 to check the tools you need.
It is advisable to change the opening direction of the door between two people.
Fig. 4
A. Tools not supplied
1. 8-mm tube wrench
2. Flat-head screwdriver
3. Spatula
4. Crosshead screwdriver
5. Wrench
6. 8-mm wrench
B. Additional parts (included in the plastic bag)
7. Upper left hinge cover
To reverse the door opening direction, follow these steps:
1. Open the door, remove every door shelf (to prevent any damage) and then close the door. To
remove the shelves, slightly press the shelf and move it upwards. Fig. 5
2. Use a spatula (3) or a flat-head screwdriver (2) to lift the screw gap cover (8) on the upper
left corner of the refrigerator and the cover of the upper right hinge (9). Fig. 6
ENGLISH
55
COOLMARKET 1D 242 WHITE