Power Function; Stop&Go Function - Kuppersbusch KI6870.0SR Instrucciones De Uso

Fig.7
undesired operations. This function is
useful as a childproof safety.
(6) for at least one second. Once
on indicating that the control panel is
simply touch sensor
If the on/off sensor
to turn off the appliance while the
possible to turn the cooktop on again
until it unblocks.
Silencer of the beep
Table 1
FOR ANY COOKING ZONE
(depending
on model)
touch key
key (6) simultaneously for three
each action will be deactivated. The
This deactivation will not be applied
or the locking/unlocking of the touch
keys always remain activated.
To once again activate all the beeps
simultaneously press the touch key
(11) and the locking touch key
for three seconds. The time indicator
Stop&Go Function
This function puts the cooking process
on pause. The timer will also be
paused if it is activated.
Activating the Stop&Go function.
(6) again.
Touch the Stop &Go sensor
(1) is used
.The power indicators will show the
symbol
been paused.
Deactivating the Stop&Go function
Touch Stop&Go sensor
The cooking is resumed under the
same power and timer settings that
centered 2 points
on 1 point covered
8 cm 22 cm
- 15 cm
(11) and the locking touch
(6)
(6)
to indicate cooking has
(6) again.
4 points
vertical
covered
24 cm
-
were established before the pause.

Power Function

Said power depends on the size of the
the maximum value permitted by the
generator.
1 S l i d e t h e f i n g e r a b o v e t h e
corresponding cursor slider (2)
until the power indicator (3) shows
second.
2 The power level indicator (3) will
will start to supply extra power.
The Power function has a maximum
adjust to 9. A beep sounds.
either by means of touching cursor
repeating step 3.
Timer Function
(countdown clock)
This function facilitates cooking given
that you don't have to be present: You
simultaneously program each plate for
durations ranging from 1 to 99 minutes.
Setting a timer on a plate.
Once the power level is set on the
be able to be timed.
To that end:
1 Touch sensor (10) or
and corresponding zone indicator
(3) will show the symbol
EN
(11).
blinking
49