Water Tank & Drain Hose - INVENTOR CB-WUI-20L Manual De Usuario

9. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have switched
off and unplugged the unit.
1. Usage of the water
When unit is OFF and the tank of the dehumidifier is full, the display will read P2. Additionally,
when the unit is on and the tank is full, the compressor stops operation followed by the fan a
few minutes later. The display will show P2.
• Lift the dehumidifier from the handle and separate it from the water tank carefully. Place the
dehumidifier aside.
• Empty the water from the tank and connect it again with the dehumidifier. The water tank,
must be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be emptied into a floor drain by attaching the unit with a water hose.
If you decide to maintain the dehumidifier inside the water
tank:
•Remove the cover located on the back of the water tank.
Using a screwdriver, push the plastic block and slide it
upwards.
•Remove the rubber plug.
•Insert the water hose into the drain outlet and make sure
all connections are firmly tightened in order to avoid any
possible leaks.
If you decide to use the buckteless mode
for continuous drainage:
•Simply remove the rubber plug from
the water drain hose outlet.
•Insert the water hose and make sure all
connections are firmly tightened.
EN
• When you remove the tank, do not touch any parts inside
the unit, as you may damage the device.
• Be sure to gently place the dehumidifier into the tank.
• Do not drink or use the collected water from the device.
• Wipe any excess water on, or in, the unit when removing
the tank.
water drain
hose outlet
27