Control Panel • Functions - INVENTOR CB-WUI-20L Manual De Usuario

8. CONTROL PANEL • FUNCTIONS
POWER
By pressing the "POWER" button the dehumidifier turns on or off. The "Power" button and Display
will turn on or off.
• When the set humidity is reached, the Energy Savings function is automatically
activated during which the digital control display of the device may show increased
humidity levels. This is because the fan is not operating. After the predetermined
timeframe and if the humidity levels have increased, the device will resume
dehumidification.
• In the event of a power failure the unit has an Auto Restart function. Once power
is restored, the appliance will automatically restart at the preselected settings prior
to the power failure.
The unit will make a noise each time the compressor starts or
stops running. This noise is totally normal.
In case of a power failure the dehumidifier will resume the
previously set operation after a time period of 3 minutes.
MODE
By pressing the "MODE" button, various operations may be selected (Dryer, Cont., Smart).
While changing operation modes, device will make a short beep.
Dryer
Dryer mode: Press the mode button
and the Dryer mode will be selected. The desired humidity level cannot be adjusted during
this mode. In addition the fan speed cannot be adjusted and will be set automatically to high
fan speed level.
After operating for approximately 2 hours the unit will check the room's humidity. If under
45%RH, only the fan will operate for two hours. After the 2 hours, the unit will quit dryer
mode. If over 45%RH, the unit will operate in Turbo fan Speed for 1 hour before checking the
room's humidity again. The maximum operation time set by this mode is 10 hours and can
be reduced depending on the room size and the dampness of the clothes.
EN
until the Dryer indicator will lit on the control panel
21