Water Tank & Drain Hose - INVENTOR ΑΤΜ-25L Manual De Usuario

9. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit.
Additionally, when the unit is on and the tank is full, indicator will illuminate, and the unit
will automatically stop operating.
• Carefully remove the bucket. Grip the handle with caution, and slowly pull outwards so
the accumulated water does not overflow.
• Lift the plastic corner cap, in order to remove the accumulated water from the tank, once
the water is emptied close the plastic corner cap once again, and place the tank securely
and properly into the device.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be emptied into a floor drain by
attaching the unit with a water hose.
• Remove the rubber plug located opposite the unit.
Insert the water hose into the drain outlet and make sure
all connections are firmly tightened in order to avoid any
possible leaks.
• The dehumidifier - air purifier, should be placed on a flat
surface in an upright position.
• Lead the water hose towards a suitable drainage facility
and be certain that the water flows naturally. For correct
drainage, make sure the hose stays below the level of the
drain hose outlet.
18
• When you remove the tank, do not touch any parts inside
the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on, or in, the unit when removing
the tank.
water drain
hose outlet
EN