Indication Of Temperature, Operating Hours; And Firmware Version; Activating The Factory Settings; Reset - IMG STAGELINE TWIST-50LED Manual De Instrucciones

7.3 Indication of temperature, operating
GB
hours and firmware version
Press the button MENU (7) repeatedly until the dis-
play (9) shows the corresponding menu item:
to indicate the temperature (°C) inside the
moving head
to indicate the operating hours
to indicate the firmware version (operating
system of the moving head)
Press the button ENTER to confirm. The display
shows the desired information. To return to the pre-
vious operating mode, keep the button MENU
pressed for one second or wait for one minute and
do not press any button.

7.4 Activating the factory settings

The factory settings are suitable as basic settings,
e. g. when installing the TWIST-50LED at a new
location.
Function
DMX start address
Number of DMX channels
Show program
Light patterns in two colours no
Slave mode
Blackout mode
Music control
Microphone sensitivity
Pan direction
Tilt direction
Display
Display mode
1) Press the button MENU (7) repeatedly until the
display (9) shows
2) Press the button ENTER. On the display,
starts flashing. (To cancel, press the button
ENTER.)
3) Press the button
the button ENTER to activate the factory set-
tings. The display shows
4) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
18
Factory setting
1
8
Sh 1
SL 1
no
on
90
normal (no)
normal (no)
on
normal (no)
(Factory).
or to switch to . Press
again.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may

7.5 Reset

In case of malfunction, a reset of the moving head
may eliminate the problem:
1) Press the button MENU (7) repeatedly until the
display (9) shows
2) Press the button ENTER. During the reset, the
display shows
returns to the previous operating mode.
3) A reset is also possible during DMX mode. For
this purpose, set DMX channel 11 (in 11-channel
mode) or channel 8 (in 8-channel mode) to a DMX
value between 200 and 209 (

8 Cleaning the Moving Head

Clean the lens and the colour filter at regular inter-
vals, depending on impurities caused by dust,
smoke or other dirt particles. Only this will ensure
that light is emitted at maximum brightness. Before
you open the head, disconnect the mains plug
from the socket and let the unit cool down. Only
use a soft, clean cloth and a glass cleaner. Then
carefully wipe the parts dry.
To clean the other parts of the housing, only use
a soft, clean cloth. Never use any liquid; it may leak
into the unit and cause damage.

9 Specifications

Light source: . . . . . . . white 50 W LED
Beam angle: . . . . . . . . 15°
Rotation angle
horizontal (pan): . . . 540°
vertical (tilt): . . . . . . 270°
Power supply: . . . . . . 230 V~ / 50 Hz
Power consumption: . 160 VA max.
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . . 300 × 380 × 240 mm
Weight: . . . . . . . . . . . . 9.4 kg
Subject to technical modification.
(reset).
. Then the moving head
chapter 9.1).