Transport; Storage; Care And Service; Troubleshooting Guide - Kärcher BDS 43/Orbital C Spray Manual De Instrucciones

7. BDS 43/Orbital C Spray only:
Rinse the spray system with clean
water.
8. Wind the power cord around the ca-
ble hooks.
9. Swivel the cleaning head upwards
by lifting it by the handle.
Illustration O
Handle
1
Cleaning head
2
10.Remove the pad from the pad drive
board.
11.Clean the device with a damp cloth.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transportation.
1. Pull the tilt adjustment lever and po-
sition the handle vertically.
2. Release the tilt adjustment lever.
3. Tilt the device backwards and go to
the destination.
4. Secure the device in accordance
with the respective applicable guide-
lines to prevent it from slipping or
overturning when in transport.

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transport and storage.
1. Store the device indoors only.
2. To protect the pad, swivel the clean-
ing head upwards by lifting it by the
handle.
Illustration O
Handle
1
Cleaning head
2
12

Care and service

WARNING
Danger of injury
The device may start up unexpectedly.
Make sure the mains plug is removed
from the socket before starting any
work on the device.
1. Wash dirty pads at a maximum tem-
perature of 60°C.
2. Clean the casing of the device with a
damp cloth and then rub dry.
3. Check the power cord for damage.

Troubleshooting guide

WARNING
Danger of injury
The device may start up unexpectedly.
Make sure the mains plug is removed
from the socket before starting any
work on the device.
In the event of malfunctions that can-
not be remedied using the following in-
formation, please contact Customer
Service.
Unsatisfactory cleaning result
 Replacing a dirty pad.
 Renewing a worn pad.
 Check the suitability of the detergent
used for the application.
 Check the suitability of the pad used
for the application.
The device vibrates strongly
 Check that the pad is positioned
centrally on the pad drive board.
 Check the attachment of the pad.
The pad does not rotate
 Check whether any foreign objects
are blocking the pad drive board.
Remove any foreign objects if nec-
essary.
 Plug the mains plug into the socket.
English