Standard Accessories - HIKOKI SB 3608DA Instrucciones De Manejo

min- Revolution or reciprocations per minute
1
Disconnect the battery
Switching ON
Switching OFF
Lock
Switch locks to the "ON" position
Lock
Unlock
Warning
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 217.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Finish sanding and fi nish fl ooring of woodwork products.
○ Base polishing of wood-coated surfaces.
○ Finish sanding of metal surfaces.
○ Base polishing of metal-coated surfaces, rust removal,
or paint removal prior to refi nishing.
○ Surface fi nishing of slate, concrete, and similar materials.
SPECIFICATIONS
1. Power tool
Model
Voltage
No-load belt speed
Sanding belt size
Battery available for this
tool*
Weight**
* Existing batteries
series, etc.) cannot be used with this tool.
** According to EPTA-Procedure 01/2014
Also, the weight includes the dust bag.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Electronic control
○ Braking Function
Brake is activated when the switch is turned off , stopping
the motor's rotation.
○ Soft start
○ Variable speed
○ Constant speed
○ Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
○ Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can be
canceled once the tool is switched off .
2. Battery
Model
Voltage
Battery capacity
* The tool itself will automatically switch over.
11
English
SB3608DA
36 V
122–450 m/min
76 × 533 mm
Multi volt battery
4.2 kg (BSL36A18)
4.5 kg (BSL36B18)
(BSL3660/3620/3626, BSL18xx
BSL36A18
36 V / 18 V
(Automatic Switching*)
2.5 Ah / 5.0 Ah
(Automatic Switching*)