Husqvarna LP 6500 Manual De Usuario página 13

To clean the product
CAUTION:
product, attach a plastic bag tightly around
the fuel tank cap. This is to make sure that
water does not go into the venthole in the
fuel tank cap.
• Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION:
directly at the fuel tank cap, electrical
components or the engine.
• Remove grease and oil from the handle.
To do a check of the scrapers
1. Make sure that the scraper blades (A) do not touch
the drums.
2. If it is necessary, adjust the screws (B) until the
clearance (C) is 1.5 mm/0.06 in.
To do a check of the safety straps
1. Examine the safety straps at the front and the rear of
the product.
2. Examine the screws and nuts on the safety straps.
1503 - 002 - 15.07.2022
Before you clean the
Do not point the water
B
C
A
3. Replace damaged safety straps.
4. Replace damaged nuts and screws.
5. Tighten loose screws and nuts.
To do a check of the engine oil level
1. Remove the oil tank cap and dipstick.
2. Clean the oil from the dipstick.
3. Put the dipstick back fully into the oil tank.
4. Remove the dipstick.
5. Examine the oil level on the dipstick.
6. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 18 or the engine manual for the correct
type of oil.
To replace the engine oil and oil filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Unscrew the drain plug from the drain hose and
drain off all the oil into a container.
2. Install the oil drain plug and tighten it.
Technical data
Engine oil is very hot
13