cecotec BOLERO DRESSCODE 2000 AUTODOSIS Manual De Instrucciones página 79

"F03"
"F13"
"F14"
"F24"
Draining fault
Door lock fault
Door unlock fault
Overflow or too
much foam.
BOLERO DRESSCODE 2000 AUTODOSIS / BOLERO DRESSCODE 2000 AUTODOSIS SILVER
The washing machine is not drained. Stop the
programme.
Turn off the washing machine and disconnect it
from the power supply.
Check if:
The draining pipe is connected.
-
The draining pump filter is not blocked.
-
Important: Make sure the device has
-
completely cooled down before draining it.
The draining hose is frozen.
-
Plug the device again into a power supply.
-
Select and start the Spin programme or
-
hold down the On/Off icon for 3 seconds
and restart the desired programme.
If the error still appears, contact the
-
Cecotec Customer Service.
The door lock does not work properly.
-
Start a programme 3 times to check if the
-
door is locked.
Open it and close it again.
-
Press the Start/Pause icon after fixing the
-
error. If the error still appears, contact the
Cecotec Customer Service.
Door opening error
Press the Start/Pause icon.
-
The washing machine will try to open the
-
door.
The error will not disappear until you do
-
not unlock the door.
Or press the On/Off icon to restart the
-
washing machine and the error will
disappear.
The water level reaches the overflow level.
Remove it by pressing the Start/Pause icon
-
and drain the water.
Select and start the desired programme.
-
If the error occurs again, disconnect the
-
appliance from the mains and contact the
Cecotec Customer Service.
ENGLISH
79