KALLISTA P24490-CR Instrucciones De Instalación página 5

INSTALLATION INSTRUCTIONS
‰ Thread the male ends of the hoses into the valves. Do not overtighten!
‰ Thread the female ends of the hoses onto the tee.
‰ Disassemble the stopper and flange from the drain body.
‰ Apply a small bead of putty or sealant to the bottom of the flange. Insert the flange into the drain opening.
‰ Assemble the nut, flat washer, and tapered gasket (tapered side up) fully onto the drain body.
‰ From the underside of the lavatory, insert the drain body up into the drain hole.
‰ From the top of the lavatory, handtighten the flange onto the drain body until secure.
‰ Install the stopper and tighten firmly.
‰ Turn the drain body so the word KALLISTA on the stopper is straight.
‰ Tighten the drain body nut firmly while holding the drain body to maintain the stopper position.
‰ Using a damp cloth, remove any excess putty or sealant.
‰ Apply thread sealant tape to the tailpiece threads and thread the tailpiece onto the drain body.
1491057-2-A
5 of 20
3. CONNECT THE HOSES
4. INSTALL THE DRAIN
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Lavatory Faucet
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.