Adjusting The Throttle Cable; Fitting The Carrying Ring - Stihl FS 85 Manual De Instrucciones

7 Adjusting the Throttle Cable

6.3 Securing the Loop Handle
A
9
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance (A).
Recommendation: distance (A): about 20 cm
(8 in)
► Slide the handle to the required position.
► Line up the loop handle (4).
► Tighten down the screws until the loop handle
can no longer be rotated on the drive tube. If
no barrier bar is fitted – lock the nuts if neces‐
sary.
The sleeve (9) (not fitted on all models) must be
between the loop handle and the control handle.
7 Adjusting the Throttle
Cable
A properly adjusted throttle cable is the precondi‐
tion for correct operation in the full throttle, start‐
ing throttle and idle positions.
Adjust the throttle cable only after the unit is fully
assembled – the control handle must be in the
normal operating position.
0458-393-8721-C
► Use a suitable tool to push the slide to the end
4
► Press down the throttle trigger lockout (1) and
8
8.1
of the slot (see illustration).
2
squeeze the throttle trigger (2) (full throttle) –
this sets the throttle cable correctly.

Fitting the Carrying Ring

Polymer Version
1
English
1
67