5 Mounting the Bike Handle
5.2.3
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
► Position the throttle cable retainer (13) and
throttle cable (12) against the drive tube.
► Close the throttle cable retainer (13). The
retainer (13) snaps into place.
5.2.4
Adjusting the Throttle Cable
► Check adjustment of throttle cable – see chap‐
ter on "Adjusting the Throttle Cable".
5.3
Mounting Bike Handle with
Swiveling Handle Support
The machine is supplied with the swiveling han‐
dle support already mounted on the shaft. To
mount the handlebar it is necessary to remove
the clamp moldings.
0458-393-8721-C
13 12
12
13
13
5.3.1
Removing the Clamp Moldings
► Hold the lower clamp (1) and upper clamp (2)
firmly together.
► Release the wing screw (3) – the clamps are
loose once the wing screw has been released.
They are pushed apart by the two
springs (4 and 5).
► Pull out the wing screw – the washer (6)
remains on the wing screw.
► Separate the clamp moldings – the
springs (4 and 5) remain in the lower clamp.
5.3.2
Securing the Handlebar
7
► Place the handlebar (7) in the lower clamp (1)
so that distance A is no more than 15 cm
(6 in).
► Place the upper clamp in position and hold
both clamp moldings together.
► Push the wing screw through the two clamps
as far as stop – hold all parts together and
secure them.
English
A
1
63