Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
NOTE: Proceed to the next step for your
specific LuminIce® kit number. Installation
varies depending on whether power for the
LuminIce® is supplied by the control board
or a switching power supply needs to be
installed.
K00465 INDIGO® NXT MODELS LOW
VOLTAGE WIRE INSTALLATION
Step 1
Route the low voltage wiring
harness from the control board to the
LuminIce®. Install wire clip and route
wires close to evaporator bulkhead to
assure harness is away from any moving
parts, then snap wire harness connectors
together.
Step 2
Route the low voltage wiring
harness through the control box low
voltage Heyco fitting and connect to the
control board LuminIce® connector.
Step 3
Test run the ice machine and
LuminIce®. A noticeable draft will be
emitted from the upper hose adapter
during operation.
14
LuminIce® Connector
K00424, K00434, K00440, K00450, K00451,
K00452 INDIGO® MODEL POWER SUPPLY
INSTALLATION PROCEDURE
Power Supply Mounting
Step 1
Route line voltage wires (black
& white) through line voltage Heyco
fitting and attach to L1 and L2 contactor
terminals.
Route Through Line Voltage Heyco
Attach to Contactor Terminals
NOTE: Three phase models do not have
open terminals on contactor. Remove
two wires from contactor, install supplied
electrical connector and connect wires.
Part Number: 000014110 Rev 01 1/19
Section 2
and
Tabla de contenido
