EAS ELECTRIC EMCH Serie Manual De Instrucciones página 65

Ocultar thumbs Ver también para EMCH Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Install the power wire at least 3 feet (1 meter) away from televisions or radios to prevent interference or
noise.
(Depending on the radio waves, a distance of 3 feet (1 meter) may not be sufficient to eliminate the noise.)
Do not wash the unit. This may cause electric shocks or fire. The appliance must be installed in accordance
with national wiring regulations. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Do not install the unit in the following places:
- Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and cause them to come
loose or water to leak.
- Where corrosive gases (such as sulphurous acid gas) are produced. Where corrosion of copper pipes or
soldered parts may cause refrigerant to leak.
- Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb the
control system and cause equipment malfunction.
- Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the air or where
volatile flammables such as paint thinner or gasoline are handled. These types of gases might cause a fire.
- Where the air contains high levels of salt such as near the ocean.
- Where voltage fluctuates a lot, such as in factories.
- In vehicles or vessels.
- Where acidic or alkaline vapors are present.
This appliance can be used by children 8 years old and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they are supervised or given
instruction on using the unit in a safe manner and understand the hazards involved. Children should
not play with the unit. Cleaning and user maintenance should not be done by children without
supervision.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufaturer or its service agent or a similarly
qualified person.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste
seperatelly for special treatment is necessary. Do not dispose of electrical appliances as municipal waste,
use seperate collection facilities. Contact your local goverment for information regarding the collection
systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substance can
leak into the groudwater and get into the food chain, damaging your health and well-being.
The wiring must be performed by professional technicians in accordance with national wiring regulation
and this circuit diagram. An all-pole disconnection device which has at least 3mm seperation distance in all
pole and a residualcurrent device(RCD) with the rating not exceeding 30mA shall be incorporated in the
fixed wiring according to the national rule.
Confirm the safety of the installation area (walls, floors, etc. ) without hidden dangers such as water,
electricity, and gas before wiring/pipes.
Before installation , check whether the user's power supply meets the electrical installation requirements of
unit ( including reliable grounding, leakage, and wire diameter electrical load, etc. ). If the electrical
installation requirements of the product are not met, the installation of the product is prohibited until
the product is rectified.
Product installation should be fixed firmly, Take reinforcement measures, when necessary.
About Fluorinated Gases
- This air-conditioning unit contains fluorinated gases. For specific information on the type of gas and the
amount, please refer to the relevant label on the unit itself. Compliance with national gas regulations shall
be observed.
- Installation, service, maintenance and repair of this unit must be performed by a certified technician.
- Product uninstallation and recycling must be performed by a certified technician.
- If the system has a leak-detection system installed, it must be checked for leaks at least every 12 months.
When the unit is checked for leaks, proper record-keeping of all checks is strongly recommended.
CAUTION
NOTE
04
V.1
Tabla de contenido
loading

Este manual también es adecuado para:

Emch-09r1Emch-12r1Emch-16r3

Tabla de contenido