DUST FILTER CLEANING AND INTEGRITY CHECK
06/2009
NOTE
also available. The following procedure is applicable
1.
Drive the machine on a level ground and engage the
parking brake.
2.
Turn the ignition key (72) to "0".
3.
Disengage the hook (18) by pulling its lower end.
4.
Remove the hopper (17) by using the handle (19) and by
disengaging it from the inner guides.
5.
cover (32).
6.
Loosen the knobs (A, Fig. 10).
7.
(B).
8.
9.
10. In an outdoor area, clean the filter by shaking it on a level
and clean surface, tapping the side (A, Fig. 11) opposite to
the wire gauze (B).
Complete the cleaning procedure by using compressed air
(C) at maximum 6 Bar, blowing only from the side protected
by the wire gauze (B), at a minimum distance of 12 in (30
cm).
•
to clean it, otherwise it can be damaged.
•
detergents. This provides better quality cleaning but
replaced more frequently. Using inadequate detergents
11. Check the filter body for tears. If necessary, replace the
12. Clean the rubber gasket (A, Fig. 12) of the cover (32) and
13. Assemble the components in the reverse order of
disassembly, and note the following:
•
11) facing upwards.
Besides the standard paper filter, polyester filters are
to each type of filter.
Unscrew the knobs (33) and remove the filter compartment
Disconnect the filter shaker motor (C) electrical connector
Remove the dust filter fastening frame (D).
Remove the dust filter (E).
According to the filter type, observe the following cautions:
Paper filter (standard): Do not use water or detergents
Polyester filter (optional): For a better cleaning, it is
allowed to wash the filter with water and non-lathering
reduces the life of the filter, which will have to be
can damage the filter.
filter.
check it for integrity and efficiency; if necessary replace it.
Install the filter (E, Fig. 10) with the wire gauze (B, Fig.
A
INSTRUCTIONS FOR USE
1464035000 - Terra™ 4300B
Figure 10
Figure 11
Figure 12
C
B
A
ENGLISH
21
S311397
S311399
S311398
E
A
D