Use/Operation; Battery Check/Setting On A New Machine - Nilfisk Advance Terra 4300B Instrucciones De Uso

USE/OPERATION

BATTERY CHECK/SETTING ON A NEW MACHINE

ENGLISH
12
WARNING!
–
–
–
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see the Visible Symbols
On The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if they are damaged.
If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed.
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
Check the batteries for damage before installation.
Disconnect the battery connector.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires four 6 V batteries, connected according to the diagram (44), or one 24 V battery box.
a) WET or GEL batteries already installed on the machine
b) Without batteries
a) WET or GEL batteries already installed on the machine
1. Open the machine hood (41)
2. Check that the batteries are connected to the machine with the connector (46).
3. Close the hood (41).
4. On first use of the machine with new batteries, perform a complete charging cycle of the batteries (see procedure in the
Maintenance chapter).
b) Without batteries
1. Buy appropriate batteries [see the Technical Data paragraph and the diagram (44)].
2. For the battery choice and installation, apply to qualified battery Retailers.
3. Install the batteries.
4. Set the machine and the battery charger according to the type of batteries installed, as shown in the next paragraph.
5. Charge the batteries (see the procedure in Maintenance chapter).
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
or connected. The batteries must be installed by qualified personnel only.
According to the type of batteries (WET or GEL/AGM), set the electronic board of the machine.
The machine can be supplied in one of the following configurations:
According to machine configuration, proceed as follows.
INSTRUCTIONS FOR USE
Terra™ 4300B - 1464035000
revised 03/2018
06/2009