Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MAIN BROOM HEIGHT CHECK AND ADJUSTMENT
ENGLISH
18
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1.
below:
•
•
Keep the machine stationary, lower the main broom
and turn it on for a few seconds.
•
Stop and lift the main broom, then move the machine
•
Check that the main broom print (A, Fig. 2), along its
length, is 0.8 to 1.6 in (2 to 4 cm) wide.
height as shown in step 2.
2.
Engage the parking brake.
3.
Turn the ignition key (72) to "0".
4.
Open the hood (7).
5.
Loosen the knob (A, Fig. 3) on the left side of the machine.
6.
Turn the knob (B), and remind that:
•
It must be screwed to lift the broom;
•
It must be unscrewed to lower the broom.
After the adjustment, hold the knob (B) and tighten the
knob (A).
7.
Perform step 1 again to check the proper adjustment of the
main broom height.
8.
When the broom is too worn out the adjustment is no more
possible; replace the broom according to the instructions in
the next paragraph.
CAUTION!
If the main broom print is excessive [larger than
overheat, thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
Check the main broom distance from the floor as shown
Drive the machine on a level floor.
and switch it off.
If the print (A) is not within specifications, adjust the broom
1.6 in (4 cm)], the machine regular operation is
affected and the moving or electrical parts can
INSTRUCTIONS FOR USE
Terra™ 4300B - 1464035000
Figure 2
Figure 3
2 - 4 cm
0,8 - 1,6 in
A
B
06/2009
S311389
S311390
A
Tabla de contenido
