Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
warnings and instructions may result in electric
shock, fire and/or serious injury.
NEVER force a charger plug into the tool.
•
DO NOT modify the charger plug of a non‑compatible
•
charger in any way to fit into the tool as the battery
may rupture causing serious personal injury.
DO NOT charge or use the battery in explosive
•
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the charger
plug from the tool may ignite the dust or fumes.
Only charge the battery with the provided charger.
•
•
DO NOT splash or immerse in water or other liquids.
DO NOT allow water or any liquid to enter tool.
•
•
DO NOT store or use the tool in locations where the
temperature may reach or exceed 104 °F (40 °C) (such
as outside sheds or metal buildings in summer). For
best life store tools in a cool, dry location.
NOTE: Do not store the tool with the switch locked on.
Never tape the switch in the ON position.
DO NOT incinerate the tool even if it is severely
•
damaged or is completely worn out. The battery can
explode in a fire. Toxic fumes and materials are created
when lithium‑ion batteries are burned.
•
If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If
battery liquid gets into the eye, rinse water over the open
eye for 15 minutes or until irritation ceases. If medical
attention is needed, the battery electrolyte is composed of a
mixture of liquid organic carbonates and lithium salts.
Contents of opened battery cells may cause
•
respiratory irritation. Provide fresh air. If symptoms
persist, seek medical attention.
•
Battery liquid may be flammable if exposed to spark
or flame.
Never attempt to open the tool for any reason. If the
•
tool case is cracked or damaged, do not charge. Do
not crush, drop or damage the tool. Do not use a tool or
charger that has received a sharp blow, been dropped, run
over or damaged in any way (e.g., pierced with a nail, hit
with a hammer, stepped on). Damaged tools should be
returned to the service center for recycling.
Storage Recommendations
The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold. Store the fully
charged tool disconnected from the charger.
Transportation
nOTE: Integral Li-ion tools should not be put in checked
baggage on airplanes.
Tool Disposal
This product uses a lithium-ion rechargeable and recyclable
battery. When the battery no longer holds a charge, the tool
should be recycled. The tool should not be incinerated or
placed in the trash.
6
The tool can be taken for disposal to an Authorized Service
Center. Some local retailers are also participating in a national
recycling program (refer to RBRC®). Call your local retailer for
details. If you bring the tool to an Authorized Service Center,
the Center will arrange to recycle the tool and its battery.
Or, contact your local municipality for proper disposal
instructions in your city/town.
The RBRC® Seal
Please take your BLACK+DECKER
with a spent battery to an authorized
BLACK+DECKER service center or to
your local retailer for recycling. In some
areas, it is illegal to place spent battery packs in the trash.
You may also contact your local recycling center for
information on where to drop off the spent battery pack. Do
not place in curbside recycling. For more information visit
www.call2recycle.org. or call the toll free number in the
RBRC® Seal.
RBRC® is a registered trademark of Call 2 Recycle, Inc.
Charging the Battery (Fig. A, B)
WARNING:
supplied charger.
WARNING:
at ambient temperatures below 39 °F (4 °C) or above
104 °F (40 °C).
From new, the rechargeable cells of the product need a
minimum charge time of 3 to 5 hours to ensure full power.
1. The switch must be in the OFF position, the tool will not
charge if it is in any other position.
2. Fig. B - Plug the jack plug
charging socket
13
of the tool.
3. Plug the charger
11
electrical outlet.
4. The charge indicator LED
housing
3
will illuminate while charging.
5. The charge indicator LED
completion of charging.
nOTE: While charging, the charger may get warm,
this is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption when
charging is complete.
ASSEMBLY AND ADJUSTMENTS
WARNING:
serious personal injury, turn unit off and lock
off the tool before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
For use only with the
Do not charge the battery
12
of the charger into the
into any standard 120 Volt 60 Hz
10
on the center of the main
10
will turn off upon
To reduce the risk of
Tabla de contenido
