Overload Protection; Overheat Protection - Makita VR001G Manual De Instrucciones

Uninstallation
1.
Open the battery case while pressing the buttons
on sides of the battery case.
2. Open the rubber sealing grommet in the battery
case.
Make sure to squeeze the rubber sealing grommet out
of the round hole rim from inside the front cover of the
case.
1
Fig.11
► 1. Rubber sealing grommet 2. Front cover
3.
Pull the adapter plug and plug cord out through
the round hole in the battery case.
4. Slide the battery adapter off from the tool while
pressing the button on front of the battery adapter.
5. Close the battery case securely.
Indicating the remaining battery
capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Fig.12
► 1. Indicator lamps 2. Check button
2
1
2
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:

Overload protection

When the tool or battery is operated in a manner that
causes it to draw an abnormally high current, the tool
stops automatically. In this situation, turn the tool off
and stop the application that caused the tool to become
overloaded. Then turn the tool on to restart.
NOTE: If the tool does not restart smoothly, cease
operation for a period longer than one minute, or
remove the battery cartridge from the tool and place it
back in the tool before a restart.

Overheat protection

When the tool or battery is overheated, the tool stops
automatically. In this case, let the tool and battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
8 ENGLISH
Off Blinking
75% to 100%
malfunctioned.
Remaining
capacity
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have