Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PROBLEM
Motor does not run
Suction capacity decreases
Vacuum stops running
Dust comes out while vacuuming
TROUBLESHOOTING
Make certain the attachment is fully pushed into the Power Unit.
Ensure the on/off switch is in the ON position (I)
Remove blockages in the suction nozzle, suction tube, suction hose or filters
Replace the paper or flee
Check for proper installation of the filters.
Clean or replace the filters.
Empty canister, refer to Emptythe tank under operating. instructions
Thermal overload has been tripped:
1. Turn the vacuum off and disconnect vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate outlet and turn on/off switch to the
ON position ( I) to test. If vacuum will not restart call 1-888-899-0146
Check for proper installation of the filters.
Ensure filters are not damaged; replace if necessary.
Ensure filter seals are in place and are secure.
POSSIBLE SOLUTION
ENGlIsh
25
Tabla de contenido
