Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Estimated Assembly Time: 10 - 20 minutes.
WARNING
!
To avoid injury, always keep the plug disconnected
from the power source and the switch turned OFF
until the sander is completely assembled and
adjusted properly.
MOUNTING WORKTABLE ON DISC (FIG. A, B )
The worktable is used with the sanding disc. It should
be used to support workpieces in all sanding operations
except inside curve applications.
1. Bag "E" - Locate worktable handles (1) and washers
(2) in parts bag.
2. Place the worktable (3) onto the sander frame,
aligning the semi-circle slot (4) with the threaded
hole (5).
3. Place a washer (2) on threaded shaft of each
worktable handle (1 ), insert through semi-circular
slot (4), and tighten into threaded hole (5). Repeat on
other side of table.
4. Adjust worktable to level or to angle desired for
sanding.
Fig. A
1
2
3
4
2 1
CAUTION
!
To avoid trapping the workpiece or fingers between
the worktable (1) and sanding disc (2) , the
worktable edge should be positioned a maximum of
1/16 in. (1.6 mm) from sanding disc plate as shown
in Fig. B.
Fig. B
1/16 in. (1.6 mm)
1
ASSEMBLY AND ADJUSTMENTS
5
2
MOUNTING WORKTABLE ON BELT (FIG. C, D )
The worktable is used with the sanding belt. It should
be used to support workpieces in all sanding operations
except inside curve applications.
1. Loosen the inner hex screw (1), and raise the belt
bed (2) in the vertical position. Tighten the inner hex
screw (1).
Fig. C
2. Bag "E" - Locate worktable knob (3) and washer (4)
in parts bag.
3. Place the worktable (5) onto the sander frame,
aligning the semi-circle slot (6) with the threaded
hole (7).
4. Place washer (4) on threaded shaft of worktable
knob (3 ), insert through semi-circular slot (6), and
tighten into threaded hole (7).
5. Adjust worktable to level or to angle desired for
sanding.
Fig. D
3 4
5
6
CAUTION
!
To avoid trapping the workpiece or fingers between
the worktable and sanding belt, the worktable
edge should be positioned a maximum of 1/16 in.
(1.6 mm) from sanding belt.
10
1
1
2
7
Tabla de contenido
