Introduction - Optimus IF-7W60DCETH Manual De Instrucciones

1. INTRODUCTION

Wall-mounted power amplifier with IP connection for
COMPACT systems.
The IF-7WDCETH series offers different amplifier
powers depending on the model:
IF-7WDC60ETH
IF-7W12DC0ETH
IF-7W150DCETH
IF-7W250DCETH
IF-7W300DCETH
IF-7W460DCETH
The built-in class D amplifiers offer high efficiency
(90%).
It has dual AC and DC power supply for emergency power supply installations. The high efficiency of the Class D minimizes power
consumption, reducing the number of batteries required in emergency power installations.
Optionally, it can include the IF-MER module which incorporates to the IF-7WDCETH two local analogue inputs (music and paging,
with configurable sensitivity 0dB / -20dB) and a surety paging relay.
Main features:

Dual Ethernet connection for installations with redundant
network systems. The connection is constantly monitored
and switches automatically if necessary.

Dual AC and DC power supply: Full range power supply
(100-240Vac 50/60 Hz) and 24VDC.

Pre-recorded messages resident in the equipment,
remotely updatable by Call Point software via IP, located
in internal Micro SD memory (16 GB).

DSP and monitoring functions.
DSP functions:
Volume, bass and treble controls or 10-band graphic
equalizer via Call Point software.
Surveillance functions:
- Loudspeaker line monitoring: (open line, short circuit,
low impedance, high impedance or line in good
condition.
- Monitoring of the amplifier status, analysing the audio
signal to detect whether the power amplifier has gone
into protection or is switched off.
- From the pre-recorded messages stored in the
equipment.
IF-7WDCETH version 5.2.001 ENG
IF-7WDCETH
4ETH
60W
120W
150W
250W
300W
460W
Class D wall-mounted amplifier
Figure 1

Digital audio reception via IP connection.

Receiving and sending control data via IP connection.

CAN bus communication with peripherals (NS-CAN and
NSD-CAN, ME-200C*, MD-30C*).
* Requires accessory module IF-MER for analogue inputs.

Monitoring of equipment operation via software and/or
basic TELNET or SSH (Secure Shell) functions.

IP address configuration in Flash memory, via software.

Constant (IP) notification of the status of the equipment
via "Heart Beat".

Pre-recorded messages resident in the equipment,
remotely updatable by Call Point software via IP, located
in internal Micro SD memory (16 GB).

Communication with external systems:
- VoIP: direct call reception from any digital VoIP
telephone using standard SIP protocols. Incorporates
zone selection by sending DTMF tones. It offers the
possibility to protect access via password.
- Direct integration (XML, API/DLL and SNMP).
with IP connection
4